Shijiazhuang Hanjiu Technology Co.,Ltd
Shijiazhuang Hanjiu Technology Co.,Ltd
Add to Cart
OEM 220936,125564 original replacement MACDON, IH Draper side belt,4belt hydraulic motors
40CC 4 BOLT Hydraulic Motor to fit SIDE DRAPER belt on -
MacDon D50, D60, D65, FD70, FD75
IH 2142, 2152, 2162
Cross Reference: MLHPQ40CN4UP08D, 101-1749-009
Characteristic Features
♦ Advanced manufacturing devices for the Gerolor gear set, which use low pressure of start-up, provide smooth reliable operation and high efficiency.
♦ Shaft seal can bear high pressure of back and the motor can be used in parallel or in series.
♦ Special design in the driver-linker and prolong operating life.
♦ Special design for distribution system can meet the requirement of low noise of unit.
♦ Compact volume and easy installation.
♦ The output shaft, with the deep groove ball bearing, can bear certain axial force and radial force.
♦ With two inner check valves, no drain connection.
Maintenance of Hydraulic Systems
Lack of maintenance of hydraulic systems is the leading cause of component and system failure yet most maintenance personnel don't understand proper maintenance techniques of a hydraulic system. The basic foundation to perform proper maintenance on a hydraulic system has two areas of concern.
The first area is Preventive Maintenance which is key to the success of any maintenance program whether in hydraulics or any equipment which we need reliability. The second area is corrective maintenance, which in many s can cause additional hydraulic component failure when it is not performed to standard.
A list of Preventive Maintenance Task for a Hydraulic System could be:
|
1. Change the (could be the return or pressure filter) hydraulic filter.
|
|
2. Obtain a hydraulic fluid sample.
|
|
3. Filter hydraulic fluid.
|
|
4. Check hydraulic actuators.
|
|
5. Clean the inside of a hydraulic reservoir.
|
|
6. Clean the outside of a hydraulic reservoir.
|
|
7. Check and record hydraulic pressures.
|
|
8. Check and record pump flow.
|
|
9. Check hydraulic hoses, tubing and fittings.
|
|
10. Check and record voltage reading to proportional or servo valves.
|
|
11. Check and record vacuum on the suction side of the pump.
|
|
12. Check and record amperage on the main pump motor.
|
|
13. Check machine cycle time and record.
|
Preventive Maintenance is the core support that a hydraulic system must have in order to maximize component and life and reduce system failure. Preventive Maintenance procedures that are properly written and followed properly will allow equipment to operate to its full potential and life cycle.
Preventive Maintenance allows a maintenance department to control a hydraulic system rather than the system controlling the maintenance department. We must control a hydraulic system by telling it when we will perform maintenance on it and how much money we will spend on the maintenance for the system. Most companies allow the hydraulic system to control the maintenance on them, at a much higher cost.